How to flash your Wyze Cam firmware manually

Flash Firmware for Wyze Cam v1

  1. Wyze Cam v1 firmware files can be found on the Release Notes page.
  2. Download the specific version of firmware from the Release Notes, For Windows 10 right-click in the folder and select extract all. For Mac: just drag and drop folder, and put it on the root directory of your microSD card and rename it to FIRMWARE_660R_F.BIN.
  3. Power off your camera and insert your MicroSD card.
  4. Hold the setup button, plug in your USB cable, and keep holding the setup button for 12-15 seconds, then release the button.
  5. Wait for 3-4 minutes. The camera will reboot and change light status during this time.
  6. After it is done, the camera light should be flashing yellow (ready to set up).
  7. Re-setup your device as a new device.

Flash Firmware for Wyze Cam v2 & Wyze Cam Pan

  1. Wyze Cam v2 and Pan firmware files can be found on the Release Notes page.
  2. Download a specific version of firmware, For Windows 10: Right-click on the folder and select extract all. For Mac: Just drag and drop the folder, put it on the root directory of your microSD card. For both Mac and Windows, rename the file to demo.bin.
  3. Power off your camera and insert your microSD card.
  4. Hold the setup button, plug in your USB cable, keep holding the setup button for 3-6 seconds until the light is solid blue, then release the button.
    • Note: The "Solid Blue" in this case is not the same as the one normally seen on the camera. Instead, both the blue and yellow LEDs will be on at once, making it appear to be a lighter blue.
  5. Wait for 3-4 minutes. The camera will reboot and change light status during this time.
  6. Once this is done, your camera should be functioning with the original setup. No need to re-setup your camera!

Flash Firmware for Wyze Cam v3

  1. Wyze Cam v3 files can be found on the Release Notes page.
  2. Download a specific version of firmware, For Windows 10: Right-click on the folder and select extract all. For Mac: Just drag and drop the folder, put it on the root directory of your microSD card. For both Mac and Windows, rename the file to demo_v3.bin.
  3. Power off your camera and insert your microSD card.
  4. Hold the setup button, plug in your USB cable, keep holding the setup button for 3-6 seconds until the light is solid purple, then release the button.
    • Note: For "Solid Purple" both the blue and red LEDs will be on at once, making it appear to be a solid purple.
  5. Wait for 3-4 minutes. The camera will reboot and change light status during this time.
  6. Once this is done, your camera should be functioning with the original setup. No need to re-setup your camera!
Was this article helpful?
473 out of 1497 found this helpful
Have more questions? Submit a request